Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Chevrolet >> 2012 >> Cruze LS, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 202 (Lighting System) >> Diagnostic Information and Procedures >> DTC B3883 >> Circuit/System Testing

Circuit/System Testing

WARNING: This page is about a different car, the 2011 Chevrolet Cruze. However, it is still accessible from the selected car via links, so may be relevant.
  1. Ignition OFF, disconnect the harness connector at the E7 License Plate Lamp.
  2. Test for less than 5 Ω between the E7 License Plate Lamp ground circuit harness connector terminal 1 and ground.
    • If greater than the specified value, test the ground circuit for an open/high resistance.
  3. Connect a test lamp between the E7 License Plate Lamp control circuit harness connector terminal 2 and ground.
  4. Command the License Plate Lamp test with a scan tool. The test lamp should turn ON and OFF when changing between the commanded states.
    • If the test lamp is always ON, test the control circuit for a short to voltage. If the circuit tests normal, replace the K9 Body Control Module.
    • If the test lamp is always OFF, test the control circuit for a short to ground or an open/high resistance. If the circuit tests normal, replace the K9 Body Control Module.
  5. If all circuits test normal, test or replace the E7 License Plate Lamp.
scientia non olet · About Mike's Workshop Manuals