Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Chevrolet >> 2012 >> Cruze LS, Automatic Trans >> Repair and Diagnosis >> Body & Frame >> Door Locks >> Power Door Lock System And Release Systems >> Diagnostic Information and Procedures >> DTC B3155 >> Circuit/System Testing

Circuit/System Testing

  1. Ignition OFF, disconnect the harness connector at the T10N Keyless Entry Antenna - Passenger Door Handle.
  2. Ignition ON, verify the scan tool Exterior Passenger Door Handle Proximity Sensor parameter is Inactive.
    • If not the specified value, test the signal circuit terminal 3 for a short to ground. If the circuit tests normal, replace the K84 Keyless Entry Control Module.
  3. Connect the a 3 A jumper harness between the signal circuit terminal 3 and ground. Verify the scan tool Exterior Passenger Door Handle Proximity Sensor parameter is Active.
    • If not the specified value, test the signal circuit terminal 3 for an open/high resistance. If the circuit tests normal, replace the K84 Keyless Entry Control Module.
  4. If all circuits test normal, replace the T10N Keyless Entry Antenna - Passenger Door Handle.
scientia non olet · About Mike's Workshop Manuals