Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Chevrolet >> 2012 >> Corvette Base, 2D Convertible, Automatic Trans >> Repair and Diagnosis >> Engine Mechanical >> Fuel System >> Engine Controls/Fuel - Repair Instructions >> Repair Instructions >> Manifold Absolute Pressure Sensor Replacement (6.2L LS3, 7.0L LS7) >> Removal Procedure

Removal Procedure

    Fig 1: Oil Filler Cap, Right Sight Shield, MAP Sensor & Electrical Connector
    GM1464034Courtesy of GENERAL MOTORS COMPANY
  1. Remove the oil filler cap (1).
  2. Remove the right engine sight shield (2).
  3. Remove the manifold absolute pressure (MAP) sensor (4).
  4. Disconnect the electrical connector (3) for the MAP sensor.
scientia non olet · About Mike's Workshop Manuals