Removal Procedure

WARNING: This page is about a different variant/trim than selected.

NOTE:

Clean all the fuel pipe connections and surrounding areas before disconnecting the pipes in order to avoid possible fuel system contamination.

Fig 1: Identifying Fuel Pipe Retainer Nuts & Bracket Bolt

Courtesy of GENERAL MOTORS COMPANY

Relieve the fuel system pressure. Refer to Fuel Pressure Relief (Without CH-48027) , Fuel Pressure Relief (CH-48027) .
Disconnect the chassis fuel feed pipe from the engine compartment feed pipe. Refer to Metal Collar Quick Connect Fitting Service .
Cap the fuel pipe in order to prevent possible fuel system contamination.
Remove the fuel pipe retainer nuts (1).
Remove the fuel pipe bracket bolt (2).

Fig 2: Identifying Pipe & Retainer

Courtesy of GENERAL MOTORS COMPANY

Remove the fuel pipe retainer (1).
Pull straight up on the pipe (2) in order to remove the pipe from the fuel meter body.

Fig 3: Identifying Fuel Meter Body Components

Courtesy of GENERAL MOTORS COMPANY

Remove and discard the following components from the fuel meter body.
- Fuel seal retainer (1)
- Upper fuel seal (2)
- Spacer ring (3)
- Lower fuel seal (4)