Circuit/System Verification (Object Detection System - Park Assist System)
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2013 GMC Savana, 2013 GMC RV Cutaway, 2013 GMC Cutaway, 2013 Chevrolet RV Cutaway, and 2013 Chevrolet Express. However, it is still accessible from the selected car via links, so may be relevant.
- Ignition ON.
- Verify that DTC B2545 is not set.
- If the DTC is set
Refer to DTC B2545 .
- If the DTC is not set
- If the DTC is set
- Verify the rearview camera has no debris on the lens and that the bezel or bezel seal is not damaged.
- If debris is found on the lens
Clean the lens. If the lens, bezel, or bezel seal are damaged, replace as necessary.
- If no debris on the lens
- If debris is found on the lens
- Ignition ON, transmission in REVERSE.
- Verify the backup lamps are On.
- If the backup lamps are not ON
Refer to Backup Lamps Malfunction .
- If the backup lamps are ON
- If the backup lamps are not ON
- Engine running, transmission in REVERSE.
- Verify a clear rear vision image is displayed on the radio.
- If a clear image is not displayed
Refer to Circuit/System Testing below.
- If a clear image is displayed
- If a clear image is not displayed
- All OK.