Theft Deterrent Module Replacement

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2011 GMC Savana Special, 2011 GMC Savana Camper Special, 2011 GMC Savana, 2011 Chevrolet RV Cutaway, and 2011 Chevrolet Cutaway. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Theft Deterrent Module

Courtesy of GENERAL MOTORS CORP.

Callout	Component Name
Preliminary Procedure Disable the SIR. Refer to SIR Disabling and Enabling . Remove the ignition lock cylinder. Refer to Ignition Lock Cylinder Replacement .
1	Theft Deterrent Module Assembly Procedure Pull the theft deterrent module out away from lock cylinder case and disconnect the electrical connector. Refer to Control Module References for programing and setup of the theft deterrent control module after replacement.

Callout

Component Name

Preliminary Procedure

Disable the SIR. Refer to SIR Disabling and Enabling .
Remove the ignition lock cylinder. Refer to Ignition Lock Cylinder Replacement .

Theft Deterrent Module Assembly

Procedure

Pull the theft deterrent module out away from lock cylinder case and disconnect the electrical connector.
Refer to Control Module References for programing and setup of the theft deterrent control module after replacement.