Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Chevrolet >> 2012 >> Chevy Express H1500, Van Cargo >> Repair and Diagnosis >> External Pages >> Different car >> Section 1947 (Power Steering System) >> Repair Instructions >> Power Steering Pump Flow Control Valve Replacement - Off Vehicle >> Assembly Procedure

Assembly Procedure

WARNING: This page is about a different car, the 2011 GMC Savana and 2011 Chevrolet Chevy Express. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Power Steering Pump Flow Control Valve Assembly
    GM580317Courtesy of GENERAL MOTORS CORP.
  1. Ensure the flow control spring (5) does not fall out of the pump housing (1).
  2. Lubricate the NEW O-ring seal (3) with power steering fluid.
  3. Install the O-ring seal onto the connector and fitting assembly (2).
  4. Install the control valve assembly (4).
    5. CAUTION:

    Refer to Fastener Caution .

  5. Install the connector and fitting assembly (2) and tighten to 62 N.m (46 lb ft).
scientia non olet · About Mike's Workshop Manuals