Circuit/System Testing
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2011 GMC Savana Special, 2011 GMC Savana Camper Special, 2011 GMC Savana, 2011 Chevrolet RV Cutaway, and 2011 Chevrolet Cutaway. However, it is still accessible from the selected car via links, so may be relevant.
Speaker Circuit Malfunction
- Ignition OFF, inspect the appropriate speaker and the surrounding interior trim for proper and secure mounting. Improper speaker mounting or loose trim may cause an audible buzz or distortion.
- If the speaker or surrounding interior trim is found to be loose or improperly secured, correctly secure the item.
- Disconnect the harness connector at the appropriate speaker.
- Radio ON, test for 5.0-7.5 V between the signal circuit terminal A and ground.
- If greater than the specified range, test the signal circuit for a short to voltage. If the circuit tests normal, replace the radio.
- If less than the specified range, test the signal circuit for a short to ground or an open/high resistance. If the circuit tests normal, replace the radio.
- Test for 5.0-7.5 V between the signal circuit terminal B and ground.
- If greater than the specified range, test the signal circuit for a short to voltage. If the circuit tests normal, replace the radio.
- If less than the specified range, test the signal circuit for a short to ground or an open/high resistance. If the circuit tests normal, replace the radio.
- If all circuits test normal, test or replace the speaker.