Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Chevrolet >> 2012 >> Chevy Express H1500, Van Cargo >> Repair and Diagnosis >> External Pages >> Different car >> Section 1744 (Lighting System) >> Repair Instructions >> Stop Lamp Switch Replacement >> Removal Procedure

Removal Procedure

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2010 GMC Savana Special, 2010 GMC Savana Camper Special, 2010 GMC Savana, 2010 Chevrolet RV Cutaway, and 2010 Chevrolet Cutaway. However, it is still accessible from the selected car via links, so may be relevant.
    WARNING: Refer to Battery Disconnect Warning .
  1. Disconnect the battery negative cable. Refer to Battery Negative Cable Disconnection and Connection .
    2. Fig 1: Identifying Air Brake Pedal Assembly
    GM161509Courtesy of GENERAL MOTORS CORP.
  2. Disconnect the electrical connector from the stop lamp switch.
  3. Remove the retainer from the brake pedal pin.
  4. Remove the stop lamp switch and the pushrod to the power brake booster from the brake pedal pin.
  5. Unsnap the stop lamp switch from the power brake booster pushrod.
scientia non olet · About Mike's Workshop Manuals