Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Chevrolet >> 2012 >> Chevy Express H1500, Van Cargo >> Repair and Diagnosis >> External Pages >> Different car >> Section 1744 (Lighting System) >> Repair Instructions >> Cargo Lamp Replacement >> Installation Procedure

Installation Procedure

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2010 GMC Savana Special, 2010 GMC Savana Camper Special, 2010 GMC Savana, 2010 Chevrolet RV Cutaway, and 2010 Chevrolet Cutaway. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Identifying Cargo Lamp
    GM820739Courtesy of GENERAL MOTORS CORP.
  1. Install the light assembly into the vehicle with double sided tape.
    2. IMPORTANT: In order to insure a good replacement of new adhesive or of old adhesive, verify that the surface meets the following conditions:
    • The temperature of the surface is approximately 24-41°C (80-105°F).
    • The surface is clean.
    • The surface is free of wax or of oily film.
  2. Connect the electrical connector.
scientia non olet · About Mike's Workshop Manuals