Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Chevrolet >> 2012 >> Caprice 6.0 2 >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 2 (Engine Controls/Fuel - 3.6L - Repair Instructions) >> Repair Instructions >> Mass Airflow Sensor with Intake Air Temperature Sensor Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: MAF Sensor And Air Cleaner Assembly Screws
    GM2660726Courtesy of GENERAL MOTORS COMPANY
  1. Install a NEW MAF sensor (1) to the air cleaner assembly (4).
    2. CAUTION:

    Refer to Fastener Caution .

  2. Install the MAF sensor to air cleaner assembly screws (3) and tighten to 1 Y (9 lb in).
  3. Connect the MAF sensor harness connector (2) to the NEW MAF sensor (1).
  4. Connect the battery negative cable. Refer to Battery Negative Cable Disconnection and Connection (Primary) , Battery Negative Cable Disconnection and Connection (Auxiliary) .
scientia non olet · About Mike's Workshop Manuals