Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Chevrolet >> 2012 >> Caprice 6.0 2 >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 2 (Engine Controls/Fuel - 3.6L - Repair Instructions) >> Repair Instructions >> Manifold Absolute Pressure Sensor Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: Intake Manifold Assemble
    GM2219477Courtesy of GENERAL MOTORS COMPANY
  1. Install a NEW MAP sensor seal.
  2. Install the MAP sensor (2) to the intake manifold assembly.
    3. CAUTION:

    Refer to Fastener Caution .

  3. Install the MAP sensor to intake manifold retaining bolt (1) and tighten to 4 N.m (35 lb in).
  4. Connect the engine wiring harness to the manifold absolute pressure (MAP) sensor (2).
scientia non olet · About Mike's Workshop Manuals