Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Chevrolet >> 2012 >> Caprice 6.0 2 >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 2 (Engine Controls/Fuel - 3.6L - Repair Instructions) >> Repair Instructions >> Fuel Pump Flow Control Module Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different variant/trim than selected.
  1. Open the liftgate.
    2. NOTE:

    When a suitable hold open device is being removed or installed, provide alternate support.

  2. Install a suitable liftgate brace to the vehicle.
  3. Remove the left side rear compartment side trim panel access hole cover.
  4. Remove the battery. Refer to Battery Replacement .
  5. Remove the battery tray. Refer to Battery Tray Replacement .
    6. Fig 1: Fuel Pump Flow Control Module And Battery Tray
    GM2290952Courtesy of GENERAL MOTORS COMPANY
  6. Remove the fuel pump flow control module to battery tray underside retaining nut (2).
  7. Detach the fuel pump flow control module retainers (4).
  8. Remove the fuel pump flow control module (1) from the battery tray (3).
scientia non olet · About Mike's Workshop Manuals