Installation Procedure
WARNING: This page is about a different car, the 2011 Chevrolet Caprice. However, it is still accessible from the selected car via links, so may be relevant.
- From outside the vehicle, install the radio antenna module and harness to the vehicle by threading through the cavity.
- Install the radio antenna module to roof panel retaining clip (1).
- Install the radio antenna module to roof panel retaining bolt (3).
Tighten
Tighten the bolt to 4 N.m (35 lb in).
- Install the radio antenna module ground point to roof panel retaining bolt (2).
Tighten
Tighten the bolt to 2 N.m (18 lb in).
- Connect the radio antenna module electrical connector.
- Install the headlining trim assembly. Refer to Headlining Trim Panel Replacement .
CAUTION:
Refer to Fastener Caution .