Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Chevrolet >> 2012 >> Caprice 6.0 2 >> Repair and Diagnosis >> External Pages >> Different car >> Section 147 (Lighting System) >> Repair Instructions >> Stop Lamp Switch Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2011 Chevrolet Caprice. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the instrument panel lower left trim plate assembly. Refer to Instrument Panel Insulator Panel Replacement - Left Side .
  2. Remove the knee bolster. Refer to Knee Bolster Replacement .
    3. Fig 1: Identifying Brake Pedal Position Sensor, Electrical Connector, Locating Tab & Brake Pedal Bracket
    GM1943573Courtesy of GENERAL MOTORS CORP.
  3. Disconnect the brake pedal position sensor electrical connector (1).
  4. Remove the brake pedal position sensor to brake pedal bracket retaining bolt (4).
  5. Disengage the brake pedal position sensor locating tab (3) from the brake pedal bracket (2).
  6. Remove the brake pedal position sensor (5).
scientia non olet · About Mike's Workshop Manuals