Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Chevrolet >> 2012 >> Camaro ZL1, Automatic Trans >> Repair and Diagnosis >> Engine Performance >> System >> Engine Controls/Fuel - 6.2L - DTC P0010 To DTC P0340 >> Diagnostic Information and Procedures >> DTC P0128 >> Circuit/System Testing

Circuit/System Testing

NOTE:

All electrical components and accessories must be turned OFF and allowed to power down.

  1. Ignition OFF, disconnect the harness connector at the B34 engine coolant temperature sensor.
  2. Vehicle OFF, all systems OFF. It may take up to 2 minutes for all vehicle systems to power down. Test for less than 5 Ω between the low reference circuit terminal A and ground.
    • If greater than the specified range, test the low reference circuit terminal B for an open/high resistance. If the circuit tests normal, replace the K20 engine control module.
  3. Ignition ON, verify the scan tool ECT Sensor parameter is colder than -39°C (-38°F).
    • If warmer than the specified range, test the signal circuit terminal B for a short to ground. If the circuit tests normal, replace the K20 engine control module.
  4. Install a 3 A fused jumper wire between the signal circuit terminal B and the low reference circuit terminal A. Verify the scan tool ECT Sensor parameter is warmer than 149°C (300°F).
    • If colder than the specified range, test the signal circuit for a short to voltage or an open/high resistance. If the circuit tests normal, replace the K20 engine control module.
  5. If all circuits test normal, test or replace the B34 engine coolant temperature sensor.
scientia non olet · About Mike's Workshop Manuals