Installation Procedure
WARNING:
To avoid any vehicle damage, serious personal injury or death when major components are removed from the vehicle and the vehicle is supported by a hoist, support the vehicle with jack stands at the opposite end from which the components are being removed and strap the vehicle to the hoist.
- Ignition OFF.
- Disconnect the battery negative cable. Refer to Battery Negative Cable Disconnection and Connection .
- Remove the engine cover. Refer to Engine Cover Replacement .
- Turn the fuel gauge assembly valve (3) to the open position.
- Connect the schrader valve (2) to the fuel pressure inspection valve on the fuel feed pipe.
- Open the bleed valve (1) to bleed any pressurized fuel.
- Close the bleed valve (1) when the fuel pressure has dropped to 0 kPa (psi).
WARNING:
Refer to Gasoline/Gasoline Vapors Warning
WARNING:
Refer to Relieving Fuel Pressure Warning
WARNING:
Refer to Safety Glasses Warning
WARNING:
Refer to Battery Disconnect Warning
NOTE:
Wrap a shop towel around the schrader valve (2) when connecting the fuel gauge assembly to the fuel pressure inspection valve on the fuel feed pipe to avoid fuel spilling.
NOTE:
Screw on the schrader valve quickly to avoid fuel spillage.