Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Chevrolet >> 2012 >> Camaro LS, Automatic Trans >> Repair and Diagnosis >> Engine Performance >> Engine Control Systems >> Engine Controls/Fuel - 3.6L - Repair Instructions >> Repair Instructions >> Fuel Pressure Sensor Replacement - Fuel Feed Pipe (With Tee Fitting)

Fuel Pressure Sensor Replacement - Fuel Feed Pipe (With Tee Fitting)

Fig 1: Fuel Pressure Sensor
GM2750061Courtesy of GENERAL MOTORS COMPANY
Fuel Pressure Sensor Replacement - Fuel Feed Pipe (With Tee Fitting)

Callout Component Name

Preliminary Procedure

    WARNING:

    Refer to Safety Glasses Warning .

    WARNING:

    Refer to Gasoline/Gasoline Vapors Warning .

    WARNING:

    Refer to Relieving Fuel Pressure Warning .

  1. Relieve the fuel pressure. Refer to Fuel Pressure Relief .
  2. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
1 Fuel Pressure Sensor
CAUTION:

Refer to Component Fastener Tightening Caution .

Procedure

  1. Disconnect the electrical connector.
  2. Release the fuel pressure sensor from the retaining bracket.
  3. Remove the fuel pressure sensor from the tee fitting.
  4. Inspect the rubber O-ring seal and replace as necessary.

Tighten 
15 (11 lb ft)
scientia non olet · About Mike's Workshop Manuals