Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Chevrolet >> 2011 >> Volt >> Repair and Diagnosis >> Engine Performance >> System >> Engine Controls And Fuel - 1.4L (LUU) - DTC P1400 Through DTC P2635 >> DTC P2422 >> Circuit/System Testing

Circuit/System Testing

  1. Ignition OFF, disconnect the harness connector at the Q13 evaporative emission system vent solenoid valve.
  2. Verify that a test lamp illuminates between the voltage supply circuit terminal 2 and ground.
    • If the test lamp does not illuminate, test the voltage supply circuit for a short to ground or an open/high resistance. If the circuit tests normal and the voltage supply circuit fuse is not open, test or replace the Q13 evaporative emission system vent solenoid valve.
  3. Connect a test lamp between the voltage supply circuit terminal 2 and the control circuit terminal 1.
  4. Command the EVAP leak detection pump ON and OFF with a scan tool. The test lamp should respond to the command.
    • If the test lamp is always ON, test the control circuit for a short to ground. If the circuit tests normal, replace the K20 engine control module.
    • If the test lamp is always OFF, test the control circuit for a short to voltage or an open/high resistance. If the circuit tests normal, replace the K20 engine control module.
  5. If all circuits test normal, replace the Q13 evaporative emission system vent solenoid valve.
scientia non olet · About Mike's Workshop Manuals