Circuit/System Description

A 3-way catalyst controls emissions of hydrocarbons, CO and NOX. The catalyst within the converter promotes a chemical reaction, which oxidizes the hydrocarbon(s) and the CO that are present in the exhaust gas. This process converts the hydrocarbon(s) and the CO into water vapor and CO2, and reduces the NOX, converting the NOX into nitrogen. The catalyst also stores oxygen. The ECM monitors this process by using heated oxygen sensors (HO2S) that are in the exhaust stream before and after the 3- way catalyst. The HO2S produces an output signal that the ECM uses to calculate the oxygen storage capacity of the catalyst. This indicates the ability of the catalyst to convert the exhaust emissions efficiently. The ECM monitors the efficiency of the catalyst by monitoring the HO2S during a Decel Fuel Cut Off (DFCO) event. When the catalyst is functioning properly, the post catalyst HO2S response to the fuel conditions during the DFCO event is slow compared to the response of the pre catalyst HO2S. When the post HO2S response is near that of the pre HO2S, the oxygen storage capability and efficiency of the catalyst may be degraded below an acceptable threshold.