Circuit/System Verification
- Ignition ON, engine running at normal operating temperature, verify there is no abnormal engine noise.
- If there is an abnormal engine noise, refer to Symptoms - Engine Mechanical .
- Observe the DTC information with a scan tool. Verify that DTC P0201-P0204, P0315, P0335, P0336, P0351-P0354 are not set.
- If any of the DTCs are set, refer to Diagnostic Trouble Code (DTC) List - Vehicle .
- Observe the scan tool Misfire Current Counter parameters. The Misfire Current Counters should not be incrementing.
- Operate the vehicle within the conditions for running the DTC to verify the DTC does not reset. You may also operate the vehicle within the conditions that you observed from the freeze frame/failure records data.
NOTE:
A misfire may only occur when the engine is under a load. An engine load may be necessary to verify the condition.