Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Chevrolet >> 2011 >> Traverse LS, AWD >> Repair and Diagnosis >> Engine Performance >> System >> Engine Controls And Fuel - 3.6L - DTC P0351 Through DTC P2636 And Troubleshooting >> Diagnostic Information and Procedures >> DTC P0650 >> Circuit/System Testing

Circuit/System Testing

  1. Ignition OFF, disconnect the X1 harness connector at the K20 ECM.
  2. Ignition ON, the MIL should not illuminate.
    • If the MIL illuminates, test the MIL control circuit terminal 54-X1 for a short to ground. If the circuit tests normal, replace the P16 instrument cluster.
    3. NOTE:

    The MIL is powered by a dedicated ignition voltage circuit.

  3. Connect a 3 A fused jumper wire between the MIL control circuit terminal 54-X1 and ground. The MIL should illuminate.
    • If the MIL illuminates, replace the K20 ECM.
    • If the MIL does not illuminate, test the MIL control circuit for a short to voltage or an open/high resistance. If the MIL control circuit tests normal, test the instrument cluster ignition voltage circuit for a short to ground or open/high resistance. If the circuit tests normal, replace the P16 instrument panel cluster/bulb.
scientia non olet · About Mike's Workshop Manuals