Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Chevrolet >> 2011 >> HHR LS, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 44 (Anti-Lock Brake System, Traction Control System & Stability Control System) >> Repair Instructions >> Vehicle Yaw Sensor with Vehicle Lateral Accelerometer Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2008 Chevrolet HHR. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Yaw Rate Sensor Nuts
    GM2017685Courtesy of GENERAL MOTORS CORP.
  1. Turn OFF the ignition.
  2. Remove the right front seat. Refer to Front Seat Replacement - Bucket .
  3. Remove the right side body hinge pillar trim panel. Refer to Body Hinge Pillar Trim Panel Replacement - Right Side .
  4. Carefully lift the floor carpet to access the yaw rate sensor.
  5. Disconnect the yaw rate sensor electrical connector.
  6. Remove the yaw rate sensor nuts (1).
    7. Fig 2: Yaw Rate Sensor
    GM2017689Courtesy of GENERAL MOTORS CORP.
  7. Remove the yaw rate sensor (1).
scientia non olet · About Mike's Workshop Manuals