Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Chevrolet >> 2011 >> HHR LS, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 27 (Battery, Charging System And Starting System) >> Repair Instructions >> Battery Negative Cable Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2008 Chevrolet HHR. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Battery Negative Cable
    GM1631517Courtesy of GENERAL MOTORS CORP.
  1. Install the negative battery cable (2).
    2. NOTE: Refer to Fastener Notice .
  2. Install the negative battery cable bolt (3) at the support.

    Tighten:  Tighten the bolt to 20 N.m (15 lb ft).

    3. Fig 2: Body Harness Electrical Connector
    GM1631519Courtesy of GENERAL MOTORS CORP.
  3. Connect the body harness electrical connector (1) to the battery current sensor (3).
  4. Connect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection .
scientia non olet · About Mike's Workshop Manuals