Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Chevrolet >> 2011 >> Corvette Base, 2D Convertible, Standard >> Repair and Diagnosis >> Engine Performance >> System >> Engine Controls And Fuel - 6.2L Or 7.0L - DTC P0201 Through DTC P0651 >> DTC P0336 >> Circuit/System Testing

Circuit/System Testing

NOTE: You must perform the Circuit/System Verification before proceeding with Circuit/System Testing.
  1. Ignition OFF, inspect the crankshaft position sensor for looseness and correct installation.
    • If the crankshaft position sensor is loose, inspect the sensor and the O-ring for damage, replace as necessary.
  2. Inspect the engine for the following conditions:
    • Engine oil for debris and contamination
    • Crankshaft reluctor wheel for damage
    • The timing chain, tensioner, and sprockets for wear or damage
    • If debris is found in the engine oil, inspect the internal engine components to determine the cause. Repair or replace any worn or damaged components.
scientia non olet · About Mike's Workshop Manuals