Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Chevrolet >> 2011 >> Corvette Base, 2D Convertible, Standard >> Repair and Diagnosis >> Engine Performance >> System >> Engine Controls And Fuel - 6.2L Or 7.0L - DTC P0201 Through DTC P0651 >> DTC P0230 (LS9) >> Circuit/System Testing

Circuit/System Testing

  1. Ignition OFF, disconnect the harness connector at the FPCM.
  2. Install a test lamp between the fuel pump control circuit terminal 13 and ground. Verify the test lamp turns ON and OFF as the ignition is turned ON.
    • If the test lamp does not illuminate, test the control circuit for a short to ground or open/high resistance. If the circuit tests normal, replace the ECM.
  3. Ignition ON, verify that a test lamp does not stay illuminated between the fuel pump control circuit terminal 13 and ground.
    • If the test lamp stays illuminated, test the control circuit for a short to voltage. If the circuit tests normal, replace the ECM.
  4. If all circuits test normal, test or replace the FPCM.
scientia non olet · About Mike's Workshop Manuals