Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Chevrolet >> 2011 >> Chevy Express G2500, Van Cargo Extended, 6.6 L >> Repair and Diagnosis >> External Pages >> Different car >> Section 45 (Power Steering System) >> Repair Instructions >> Power Steering Pump Flow Control Valve Replacement - Off Vehicle >> Assembly Procedure

Assembly Procedure

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2010 GMC Savana Special, 2010 GMC Savana Camper Special, 2010 GMC Savana, 2010 Chevrolet RV Cutaway, and 2010 Chevrolet Cutaway. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Power Steering Pump Control Valve Assembly
    GM580317Courtesy of GENERAL MOTORS CORP.
  1. Ensure the flow control spring (5) does not fall out of the pump housing (1).
  2. Lubricate the NEW O-ring seal (3) with power steering fluid.
  3. Install the O-ring seal onto the connector and fitting assembly (2).
  4. Install the control valve assembly (4).
    5. CAUTION: Refer to Fastener Caution .
  5. Install the connector and fitting assembly (2) and tighten to 62 N.m (46 lb ft).
scientia non olet · About Mike's Workshop Manuals