Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Chevrolet >> 2011 >> Chevy Express G2500, Van Cargo Extended, 6.6 L >> Repair and Diagnosis >> External Pages >> Different car >> Section 36 (Antilock Brake System With Traction Control System & Stability Control System) >> Repair Instructions >> Vehicle Yaw Sensor With Vehicle Lateral Accelerometer Replacement >> Installation Procedure

Installation Procedure

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2010 GMC Savana Special, 2010 GMC Savana Camper Special, 2010 GMC Savana, 2010 Chevrolet RV Cutaway, and 2010 Chevrolet Cutaway. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the yaw rate sensor and lateral accelerometer (1) to the vehicle.
    Fig 1: Identifying Yaw Rate Sensor/Lateral Accelerometer, Nuts & Electrical Connector
    GM1372891Courtesy of GENERAL MOTORS CORP.
    CAUTION: Refer to Fastener Caution .
  2. Install the yaw rate sensor and lateral accelerometer nuts (2) and tighten to 9 N.m (80 lb in).
  3. Install a scan tool.
  4. Using the special functions menu on the scan tool, reset the yaw rate sensor.
  5. Perform the Diagnostic System Check. Refer to Diagnostic System Check - Vehicle .
  6. Connect the electrical connector (3) to the yaw rate sensor and lateral accelerometer.
  7. Install the carpet.
  8. Install the passenger seat to the vehicle. Refer to Driver or Passenger Seat Replacement .
scientia non olet · About Mike's Workshop Manuals