Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Chevrolet >> 2011 >> Chevy Express G2500, Van Cargo Extended, 6.6 L >> Repair and Diagnosis >> External Pages >> Different car >> Section 15 (Cellular Systems, Entertainment Systems & Navigation Systems) >> Repair Instructions >> Radio Replacement >> Removal Procedure

Removal Procedure

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2010 GMC Savana Special, 2010 GMC Savana Camper Special, 2010 GMC Savana, 2010 Chevrolet RV Cutaway, and 2010 Chevrolet Cutaway. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the instrument cluster panel. Refer to Instrument Panel Cluster Trim Plate Bezel Replacement .
    2. Fig 1: Identifying Radio Support Bracket Screws
    GM665518Courtesy of GENERAL MOTORS CORP.
  2. Remove the screws (2) that secure the radio to the support bracket (1).
  3. Remove the radio from the support bracket enough to access the connectors at rear of the radio.
  4. Disconnect the electrical/audio and antenna cable connectors from the radio.
  5. Remove the radio.
    6. Fig 2: Locating Radio Mounting Bracket To Instrument Panel Carrier Screws
    GM639268Courtesy of GENERAL MOTORS CORP.
  6. If removing the radio mounting bracket. Perform the following steps:
    1. Detach the clip retaining the HVAC harness to the radio mounting bracket.
    2. Remove the screws (2) retaining the radio mounting bracket (1) to the instrument panel carrier.
    3. Remove the radio mounting bracket from the vehicle.
scientia non olet · About Mike's Workshop Manuals