Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Chevrolet >> 2011 >> Chevy Express G2500, Van Cargo Extended, 6.6 L >> Repair and Diagnosis >> External Pages >> Different car >> Section 14 (Data Communication System) >> Diagnostic Information & Procedures >> DTC U1814 >> Circuit/System Testing

Circuit/System Testing

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2010 GMC Savana Special, 2010 GMC Savana Camper Special, 2010 GMC Savana, 2010 Chevrolet RV Cutaway, and 2010 Chevrolet Cutaway. However, it is still accessible from the selected car via links, so may be relevant.
  1. Ignition OFF, disconnect the X1 harness connector at the ECM and the TCM one at a time. After each disconnect, test for current DTCs. DTC U1814 should remain current.
    • If the DTC becomes history, replace the module disconnected when the DTC became history.
  2. Ignition OFF, disconnect the X4 harness connector at the BCM.
  3. Test for infinite resistance between the signal circuit terminal 19 and ground.
    • If less than the specified value, test the signal circuit for a short to ground.
  4. If all circuits tests normal, replace the BCM.
scientia non olet · About Mike's Workshop Manuals