Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Chevrolet >> 2011 >> Chevy Express G2500, Van Cargo Extended, 6.6 L >> Repair and Diagnosis >> External Pages >> Different car >> Section 12 (Supplemental Inflatable Restraint System) >> Repair Instructions >> Steering Wheel Inflatable Restraint Module Replacement >> Installation Procedure

Installation Procedure

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2010 GMC Savana Special, 2010 GMC Savana Camper Special, 2010 GMC Savana, 2010 Chevrolet RV Cutaway, and 2010 Chevrolet Cutaway. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Inflatable Restraint Steering Wheel Module
    GM245799Courtesy of GENERAL MOTORS CORP.
  1. Position the inflatable restraint module to the steering wheel.
  2. Connect the electrical connectors to the inflatable restraint steering wheel module.
  3. Connect the CPA retainers into the electrical connectors. Seat and lock the connections.
  4. Fig 2: View Of Leaf Spring Fasteners
    GM760459Courtesy of GENERAL MOTORS CORP.
  5. Position the alignment posts of the inflatable restraint module to the holes that are located on the steering wheel housing.
  6. Push the inflatable restraint module into the steering wheel in order to engage and in order to latch the 2 leaf spring fasteners (1).
  7. After installation, pull the sides of the inflatable restraint module in order to ensure that both leaf spring fasteners are engaged.
  8. Enable the inflatable restraint steering wheel module. Refer to SIR Disabling and Enabling .