Installation Procedure (Battery, Charging System And Starting System)
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2010 GMC Savana Special, 2010 GMC Savana Camper Special, 2010 GMC Savana, 2010 Chevrolet RV Cutaway, and 2010 Chevrolet Cutaway. However, it is still accessible from the selected car via links, so may be relevant.
- Slide the NEW battery current sensor (1) up onto the negative battery cable.
- Using NEW tie straps and electrical tape, attach the battery current sensor to the negative battery cable.
- Install the negative battery cable. Refer to Battery Negative Cable Replacement (LMM -Primary) or Battery Negative Cable Replacement (LU3 and RVS) or Battery Negative Cable Replacement (LY2, LMF or LY6) or Battery Negative Cable Replacement (LGH - Primary) .
- Connect the I/P harness electrical connector to the battery current sensor.
NOTE:
Ensure that the tape tab is pointing away from the battery prior to installation.