Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Chevrolet >> 2011 >> Chevy Express G2500, Van Cargo Extended, 6.6 L >> Repair and Diagnosis >> Engine Performance >> System >> Engine Controls And Fuel - 6.6L (LGH) - DTC P0016 Through DTC P11DC >> Diagnostic Information and Procedures >> DTC P008F >> Testing >> Circuit/System Testing

Circuit/System Testing

  1. Ignition OFF, disconnect the harness connector at the ECT sensor.
  2. Ignition OFF and all vehicle systems OFF. It may take up to 2 minutes for all vehicle systems to power down. Test for less than 5.0 ohms between the low reference circuit terminal A and ground.
    • If greater than the specified range, test the low reference circuit for an open/high resistance. If the circuit tests normal, replace the K20 ECM.
  3. Ignition ON, verify the scan tool ECT parameter is colder than -39°C (-40°F).
    • If greater than the specified range, test the signal circuit for a short to ground. If the circuit tests normal, replace the K20 ECM.
  4. Install a 3 A fused jumper wire between the signal circuit terminal B and the low reference circuit terminal A. Verify the scan tool ECT parameter is warmer than 149°C (300°F).
    • If less than the specified range, test the signal circuit for a short to voltage or an open/high resistance. If the circuit tests normal, replace the K20 ECM.
  5. If all circuits test normal, test or replace the B34 ECT sensor.
scientia non olet · About Mike's Workshop Manuals