Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Chevrolet >> 2011 >> Chevy Express G2500, Van Cargo Extended, 6.6 L >> Repair and Diagnosis >> Engine Performance >> Engine Control Systems >> Engine Controls And Fuel - 6.6L (LGH) - Repair Instructions >> Repair Instructions >> Fuel Injector Replacement (Right Side) >> Removal Procedure

Removal Procedure

  1. Remove the upper fan shroud. Refer to Engine Coolant Fan Upper Shroud Replacement (4.3L, 4.8L, 5.3L, 6.0L, 6.2L, 7.0L) , Engine Coolant Fan Upper Shroud Replacement (Diesel) .
  2. Remove the exhaust gas recirculation bracket. Refer to Exhaust Gas Recirculation Valve Bracket Replacement .
    3. Fig 1: Injector Electrical Connectors
    GM2369735Courtesy of GENERAL MOTORS CORP.
    CAUTION:

    Label all the injector electrical connectors before the connectors are removed in order to prevent reconnecting to the wrong injector. Failure to properly connect the injectors in the correct sequence will cause severe engine damage.

  3. Disconnect the fuel injector electrical connectors (1).
    4. Fig 2: Fuel Return Pipes
    GM2369737Courtesy of GENERAL MOTORS CORP.
    CAUTION:

    Label all the injector electrical connectors before the connectors are removed in order to prevent reconnecting to the wrong injector. Failure to properly connect the injectors in the correct sequence will cause severe engine damage.

  4. Disconnect and reposition the fuel return pipes (1).
    5. Fig 3: Fuel Injector Pipes & Fasteners
    GM2369742Courtesy of GENERAL MOTORS CORP.
    NOTE:
    • Prior to removal of the fuel injector pipes, use compressed air to remove any debris from the injector line and fittings.
    • Spray lithium grease, GM P/N 12346293 or equivalent, between the fuel injector line and fittings to assist with removal.
  5. Remove the fuel pipe bracket fasteners (1) and fuel injector pipes (2).
    6. Fig 4: Fuel Injector Bracket Bolts
    GM2369743Courtesy of GENERAL MOTORS CORP.
  6. Remove the fuel injector bracket bolts (1).
    7. Fig 5: Fuel Injectors And Brackets
    GM2369744Courtesy of GENERAL MOTORS CORP.
  7. Install EN-49774  puller into the bolt hole in the fuel injector bracket.
  8. Install a flare nut wrench onto EN-49774  puller, and work the tool outward until the injector releases from its seat.
  9. Remove the EN-49774  puller.
  10. Remove the fuel injectors (1) with brackets (2).
  11. Remove and discard the copper washer from the fuel injector bore.
  12. Remove and discard the fuel injector O-ring from the injector.
scientia non olet · About Mike's Workshop Manuals