Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Chevrolet >> 2011 >> Chevy Express G2500, Van Cargo Extended, 6.6 L >> Repair and Diagnosis >> Engine Performance >> Engine Control Systems >> Engine Controls And Fuel - 6.6L (LGH) - Repair Instructions >> Repair Instructions >> Exhaust Pressure Differential Sensor Replacement >> Installation Procedure

Installation Procedure

    Fig 1: Exhaust Differential Pressure Sensor
    GM1862637Courtesy of GENERAL MOTORS CORP.
  1. Position the exhaust differential pressure sensor to the frame.
    2. CAUTION:

    Refer to Fastener Caution .

  2. Install the exhaust differential pressure sensor bracket bolt (2) and tighten to 9 N.m (80 lb in) .
  3. Install the exhaust differential pressure sensor pipe assembly hoses to the sensor.
  4. Position the exhaust differential pressure sensor pipe assembly hose clamps (1).
    5. Fig 2: Engine Wiring Harness Electrical Connector
    GM1862627Courtesy of GENERAL MOTORS CORP.
  5. Connect the engine wiring harness electrical connector (1) to the exhaust differential pressure sensor.
  6. Lower the vehicle.
scientia non olet · About Mike's Workshop Manuals