Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Chevrolet >> 2011 >> Chevy Express G1500, Van Cargo, 4.3 X >> Repair and Diagnosis >> Engine Performance >> Engine Control Systems >> Engine Controls And Fuel - 4.3L - Repair Instructions >> Repair Instructions >> Knock Sensor 1 Replacement >> Installation Procedure

Installation Procedure

    Fig 1: Knock Sensor And Bolt
    GM1877015Courtesy of GENERAL MOTORS CORP.
    CAUTION:

    Refer to Fastener Caution .

  1. Position the knock sensor to the engine block and install the bolt. Tighten to 25 N.m (18 lb ft)
    2. Fig 2: Knock Sensor Wiring Harness Electrical Connector
    GM1950124Courtesy of GENERAL MOTORS CORP.
  2. Connect the engine wiring harness electrical connector (1) to the knock sensor.
  3. Position the knock sensor sleeve up and over the knock sensor, if equipped.
  4. Lower the vehicle.
scientia non olet · About Mike's Workshop Manuals