Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Chevrolet >> 2011 >> Chevy Express G1500, Van Cargo, 4.3 X >> Repair and Diagnosis >> Engine Performance >> Engine Control Systems >> Engine Controls And Fuel - 4.3L - Repair Instructions >> Repair Instructions >> Camshaft Position Sensor Replacement >> Removal Procedure

Removal Procedure

    Fig 1: Crankshaft Position (CKP) Sensor Wiring Harness Electrical Connector
    GM1950052Courtesy of GENERAL MOTORS CORP.
  1. Disconnect the engine wiring harness electrical connector (1) from the camshaft position (CMP) sensor wiring harness jumper (2).
  2. Remove the water pump. Refer to Water Pump Replacement (V6) , Water Pump Replacement (V8) , Water Pump Replacement (Diesel) .
    3. Fig 2: CMP Sensor And Bolt
    GM1877007Courtesy of GENERAL MOTORS CORP.
  3. Remove the CMP sensor bolt.
  4. Remove the CMP sensor and wiring harness jumper from the engine front cover.
  5. Disconnect the CMP sensor wiring harness jumper from the CMP sensor.
  6. Remove the CMP sensor from the wiring harness jumper.
scientia non olet · About Mike's Workshop Manuals