Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Chevrolet >> 2010 >> Traverse LS, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 62 (Immobilizer System) >> Diagnostic Information and Procedures >> DTC B302A >> Circuit/System Verification

Circuit/System Verification

WARNING: This page is about a different car, the 2009 Saturn Outlook, 2009 GMC Acadia, 2009 Chevrolet Traverse, and 2009 Buick Enclave. However, it is still accessible from the selected car via links, so may be relevant.
  1. With a master vehicle key, turn the ignition ON.
  2. Observe the security indicator. After approximately 10 minutes, the indicator will turn off.
  3. Turn the ignition OFF and wait 5 seconds.
  4. Repeat steps 2-4 two more times for a total of 3 cycles or 30 minutes.
  5. With a master vehicle key, turn the ignition ON. The start disable will now be cleared.
  6. With a scan tool, clear any DTCs.
scientia non olet · About Mike's Workshop Manuals