Installation Procedure
WARNING: This page is about a different car, the 2009 Saturn Outlook, 2009 GMC Acadia, 2009 Chevrolet Traverse, and 2009 Buick Enclave. However, it is still accessible from the selected car via links, so may be relevant.
- Position the stabilizer shaft on the frame.
- Install the left and right stabilizer shaft insulators and brackets. Refer to Stabilizer Shaft Insulator Replacement .
- Install the stabilizer shaft links to the stabilizer shaft. Refer to Stabilizer Shaft Link Replacement .
- Using the jack stands, raise the front cradle into position.
- Tighten the front frame (2) bolts.
Tighten: Tighten the frame to body bolts to 100 N.m (74 lb ft) plus 90 degrees.
- Tighten the front frame reinforcement mounting bolts (1). Left side shown, right side similar.
Tighten: Tighten the reinforcement bolts to 50 N.m (37 lb ft).
- Tighten the rear frame mounting bolts (1). Left side shown, right side similar.
Tighten: Tighten the frame to body bolts to 100 N.m (74 lb ft) plus 90 degrees.
- Tighten the rear reinforcement bolts. Left side shown, right side similar.
Tighten: Tighten the reinforcement bolts to 50 N.m (37 lb ft).
- Remove the adjustable jack stands.
- Install the bolt from the intermediate shaft bracket to the front cradle. Refer to Front Wheel Drive Intermediate Shaft Replacement .
- Install the outer tie rod ends to the knuckle. Refer to Steering Linkage Outer Tie Rod Replacement .
- Install the rear propeller shaft, if equipped. Refer to Propeller Shaft Replacement .
- Install the front tires and wheels. Refer to Tire and Wheel Removal and Installation .
- Remove the support and lower the vehicle.
CAUTION:
Refer to Fastener Caution
.