Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Chevrolet >> 2010 >> Traverse LS, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 24 (Battery, Charging System And Starting System) >> Repair Instructions >> Battery Negative Cable Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2009 Saturn Outlook, 2009 GMC Acadia, 2009 Chevrolet Traverse, and 2009 Buick Enclave. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
  • Always use replacement cables that are of the same type, diameter and length of the cables that you are replacing.
  • Always route the replacement cable the same way as the original cable.
    Fig 1: Identifying Body Wiring Harness Connector & Negative Battery Cable Connector
    GM1860988Courtesy of GENERAL MOTORS CORP.
  1. Disconnect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection .
  2. Disconnect the body wiring harness electrical connector (4) from the negative battery cable electrical connector (1).
    3. Fig 2: View Of Negative Battery Cable Ground Bolt
    GM1860989Courtesy of GENERAL MOTORS CORP.
  3. Remove the negative battery cable ground bolt (2). (battery shown removed for clarity).
  4. Remove the negative battery cable.
scientia non olet · About Mike's Workshop Manuals