Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Chevrolet >> 2010 >> Traverse LS, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 23 (Engine Control System & Fuel System - 3.6L - Introduction) >> Repair Instructions >> Knock Sensor Replacement - Bank 2 >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2009 Saturn Outlook, 2009 GMC Acadia, 2009 Chevrolet Traverse, and 2009 Buick Enclave. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Left Knock Sensor
    GM860802Courtesy of GENERAL MOTORS CORP.
    CAUTION: Refer to Fastener Caution .
  1. Position the knock sensor and tighten the knock sensor bolt.

    Tighten:  Tighten the bolt to 23 N.m (17 lb ft).

    2. Fig 2: Identifying Knock Sensor Electrical Connector
    GM1860484Courtesy of GENERAL MOTORS CORP.
  2. Connect the engine wiring harness electrical connector (2) to the bank 2 knock sensor (3).
  3. Raise and suitably support the vehicle. Refer to Lifting and Jacking the Vehicle .
  4. Install a NEW engine oil filter. Refer to ENGINE OIL AND OIL FILTER REPLACEMENT .
  5. Connect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection .
scientia non olet · About Mike's Workshop Manuals