Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Chevrolet >> 2010 >> Traverse LS, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 23 (Engine Control System & Fuel System - 3.6L - Introduction) >> Repair Instructions >> Air Cleaner Element Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2009 Saturn Outlook, 2009 GMC Acadia, 2009 Chevrolet Traverse, and 2009 Buick Enclave. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Identifying Air Cleaner Components
    GM1860603Courtesy of GENERAL MOTORS CORP.
  1. Install a NEW air cleaner element (4).
  2. Position the air cleaner housing cover (3) (with outlet duct) onto the air cleaner lower housing.
  3. Install the air cleaner outlet duct onto the throttle body.
  4. Tighten the 6 air cleaner housing cover screws (2) until snug.
    5. CAUTION: Refer to Fastener Caution .
  5. Tighten the air cleaner outlet duct clamp (1) at the throttle body.

    Tighten:  Tighten the clamp to 4 N.m (35 lb in).

    6. Fig 2: Identifying Fresh Air Tube & Related Components
    GM2065375Courtesy of GENERAL MOTORS CORP.
  6. Connect the engine wiring harness electrical connector to the MAF/IAT sensor.
  7. Connect the PCV quick disconnect (2). Refer to Plastic Collar Quick Connect Fitting Service .
  8. Connect the PCV fresh air tube to the camshaft cover fitting (1).
  9. Install the fuel injector sight shield. Refer to FUEL INJECTOR SIGHT SHIELD REPLACEMENT .
scientia non olet · About Mike's Workshop Manuals