Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Chevrolet >> 2010 >> Traverse LS, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 23 (Engine Control System & Fuel System - 3.6L - Introduction) >> Repair Instructions >> Air Cleaner Assembly Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2009 Saturn Outlook, 2009 GMC Acadia, 2009 Chevrolet Traverse, and 2009 Buick Enclave. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Identifying Air Cleaner Lower Housing
    GM1860637Courtesy of GENERAL MOTORS CORP.
  1. Position the air cleaner lower housing to the side rail.
    2. Fig 2: Identifying ECM Retaining Tab
    GM1857963Courtesy of GENERAL MOTORS CORP.
  2. Position and install the ECM to the bracket.
    3. Fig 3: View Of EVAP Pipe
    GM1860283Courtesy of GENERAL MOTORS CORP.
  3. Connect the evaporative emission (EVAP) pipe (3) quick connect fitting to the EVAP purge solenoid. Refer to Plastic Collar Quick Connect Fitting Service .
  4. Connect the fuel feed pipe (2) quick connect fitting to the fuel rail. Refer to Metal Collar Quick Connect Fitting Service .
    5. Fig 4: Identifying Hood Release Cable Clip
    GM1926994Courtesy of GENERAL MOTORS CORP.
  5. Install the hood release cable clip (1) to the air cleaner lower housing.
    6. Fig 5: Identifying Air Cleaner Lower Housing Screws
    GM1860635Courtesy of GENERAL MOTORS CORP.
    CAUTION: Refer to Fastener Caution .
  6. Install the air cleaner lower housing screws (1).

    Tighten:  Tighten the screws to 9 N.m (80 lb in).

  7. Install the air cleaner element. Refer to Air Cleaner Element Replacement .
scientia non olet · About Mike's Workshop Manuals