Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Chevrolet >> 2010 >> Traverse LS, AWD >> Repair and Diagnosis >> Accessories & Equipment >> Cellular Systems, Entertainment Systems & Navigation Systems >> Diagnostic Information and Procedures >> Video Entertainment System Malfunction >> Circuit/System Testing

Circuit/System Testing

  1. Ignition OFF, disconnect the harness connector at the appropriate DVD display.
  2. Ignition OFF, test for less than 5.0 Ω between the ground circuit terminals listed below and ground.
    • Ground terminal 6
    • Ground terminal 5 (DNU)
    • If greater than specified range, test the ground circuit for an open/high resistance.
  3. Ignition ON, DVD playing, test for B+ between the entertainment remote enable B+ circuit terminal 8 and ground.
    • If less than specified range, test the B+ circuit for a short to ground or an open/high resistance. If the circuit tests normal, replace the radio.
  4. Ignition ON, test for B+ between the battery positive voltage circuit terminal 7 and ground.
    • If less than specified range, test the voltage supply circuit for a short to ground or an open/high resistance.
  5. Ignition ON, DVD playing, test for 1-8 V between the video bright control circuit terminal 9, and ground.
    • If greater then specified range, test the control circuit for a short to voltage. If the circuit tests normal, replace the radio.
    • If less then specified range, test the control circuit for a short to ground or an open/high resistance. If the circuit tests normal, replace the radio.
  6. Ignition ON, DVD playing, test for 0.5-3.0 V between the video mode signal circuit terminal 10, and ground.
    • If greater then specified range, test the signal circuit for a short to voltage. If the circuit tests normal, replace the radio.
    • If less then specified range, test the signal circuit for a short to ground or an open/high resistance. If the circuit tests normal, replace the radio.
  7. Ignition ON, headlamps OFF, DVD playing, test for 80-320 mV AC between the video signal (+) circuit terminal 1, and ground.
    • If greater then specified range, test the control circuit for a short to voltage. If the circuit tests normal, replace the radio.
    • If less then specified range, test the control circuit for a short to ground or an open/high resistance. If the circuit tests normal, replace the radio.
  8. If all circuits test normal, replace the DVD display.
scientia non olet · About Mike's Workshop Manuals