Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Chevrolet >> 2010 >> HHR SS, Standard >> Repair and Diagnosis >> Engine Performance >> Engine Control Systems >> Engine Controls And Fuel - 2.0L - Repair Instructions >> Repair Instructions >> Charge Air Cooler Inlet Pipe Replacement >> Removal Procedure

Removal Procedure

    Fig 1: View Of Charge Air Cooler Inlet Pipe
    GM2001806Courtesy of GENERAL MOTORS CORP.
  1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
  2. Remove the front bumper fascia extension. Refer to Front Bumper Fascia Extension Replacement .
  3. Loosen the charge air cooler inlet pipe clamp (1).
  4. Remove the charge air cooler inlet pipe (2) from the charge air cooler (3).
    5. Fig 2: Charge Air Cooler Clamp
    GM2001828Courtesy of GENERAL MOTORS CORP.
  5. Lower the vehicle.
  6. Loosen the charge air cooler clamp (1).
  7. Remove the charge air cooler inlet pipe (2) and release the pipe retaining grommet from the engine bracket.
  8. Remove the pipe from the vehicle.
scientia non olet · About Mike's Workshop Manuals