Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Chevrolet >> 2010 >> HHR LS, Standard >> Repair and Diagnosis >> Brakes >> Antilock Brake System With Traction Control System & Stability Control System >> Repair Instructions >> Vehicle Yaw Sensor with Vehicle Lateral Accelerometer Replacement >> Removal Procedure

Removal Procedure

    Fig 1: View Of Yaw Rate Sensor & Nuts
    GM2017685Courtesy of GENERAL MOTORS CORP.
  1. Turn OFF the ignition.
  2. Remove the right front seat. Refer to Front Seat Replacement - Bucket .
  3. Remove the right side body hinge pillar trim panel. Refer to Body Hinge Pillar Trim Panel Replacement - Right Side .
  4. Carefully lift the floor carpet to access the yaw rate sensor.

    To ease access to the yaw rate sensor, it may be necessary to carefully cut a small section of the floor carpeting neat the yaw rate sensor.

  5. Disconnect the yaw rate sensor electrical connector.
  6. Remove the yaw rate sensor nuts (1).
    7. Fig 2: View Of Yaw Rate Sensor
    GM2017689Courtesy of GENERAL MOTORS CORP.
  7. Remove the yaw rate sensor (1).
scientia non olet · About Mike's Workshop Manuals