Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Chevrolet >> 2010 >> Cutaway 6.6 6 >> Repair and Diagnosis >> Engine Performance >> Engine Control Systems >> Engine Controls And Fuel - 6.6L (LMM) - Repair Instructions >> Repair Instructions >> Intake Air Valve Replacement >> Installation Procedure

Installation Procedure

    Fig 1: Identifying Intake Air Valve Bolts
    GM1862033Courtesy of GENERAL MOTORS CORP.
    CAUTION: Refer to Fastener Caution .
  1. Position the intake air valve to the IAH and install the intake air valve bolts and tighten to 20 N.m (15 lb ft).
    2. Fig 2: View Of Engine Wiring Harness Electrical Connector
    GM1862030Courtesy of GENERAL MOTORS CORP.
  2. Connect the engine wiring harness electrical connector (2) to the intake air valve.
  3. Install the charge air cooler outlet pipe. Refer to Charge Air Cooler Inlet and Outlet Duct Replacement (Inlet) or Charge Air Cooler Inlet and Outlet Duct Replacement (Outlet) .
scientia non olet · About Mike's Workshop Manuals