Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Chevrolet >> 2010 >> Corvette Base, 2D Convertible, Standard >> Repair and Diagnosis >> Brakes >> Antilock Brake System With Traction Control System & Stability Control System >> Diagnostic Information and Procedures >> DTC C0186 or C0196 >> Circuit/System Testing

Circuit/System Testing

  1. Verify that DTC C0710, U2100, or U2142 and not set.
  2. Ignition OFF, disconnect the harness connector at the yaw/lateral accelerometer sensor.
  3. Ignition OFF for 60 seconds, test for less than 5 Ω between the low reference circuit terminal 1 and ground.
    • If greater than the specified range, test the low reference circuit for an open/high resistance.
  4. Ignition ON, test for B+ between the ignition voltage circuit terminal 4 and ground.
    • If not within the specified range, test the ignition voltage circuit for a short to ground or open/high resistance.
  5. If all circuits test normal, replace the yaw/lateral accelerometer sensor.
scientia non olet · About Mike's Workshop Manuals