Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Chevrolet >> 2010 >> Cobalt SS >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 4 (Engine Controls And Fuel - 2.2L - Repair Instructions) >> Repair Instructions >> Fuel Tank Pressure Sensor Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: Identifying Fuel Tank Pressure Sensor
    GM1742792Courtesy of GENERAL MOTORS CORP.
  1. Install the fuel tank pressure sensor to the EVAP canister. Ensure that the sensor grommet is fully seated to the canister.
  2. Install the fuel tank pressure sensor cover.
    3. Fig 2: View Of EVAP Canister Harness & Fuel Tank Harness Electrical Connector
    GM1652166Courtesy of GENERAL MOTORS CORP.
  3. Connect the EVAP canister harness electrical connector (1) to the fuel tank pressure sensor.
  4. Lower the vehicle.
scientia non olet · About Mike's Workshop Manuals