Installation Procedure (Battery, Charging System And Starting System)

Fig 1: View Of Battery Current Sensor

Courtesy of GENERAL MOTORS CORP.

NOTE: Ensure that the tape tab is pointing away from the battery prior to installation.

Slide the NEW battery current sensor (1) up onto the negative battery cable.
Using NEW tie straps and electrical tape, attach the battery current sensor to the negative battery cable.
Install the negative battery cable. Refer to Battery Negative Cable Replacement (LMM -Primary) or Battery Negative Cable Replacement (LU3 and RVS) or Battery Negative Cable Replacement (LY2, LMF or LY6) or Battery Negative Cable Replacement (LGH - Primary) .
Connect the I/P harness electrical connector to the battery current sensor.